Woodworking engraving machine in relief processing, we often use the 3D sculpting, out of this effect is more artistic beauty, and have a strong 3D sense, the realization of this function is mainly to design tool and tool selection, complete, in design tool path, choose to automatically generate deep and superficial change of engraving process, with a sharp knife to finish, but sometimes because between the two lines of the pattern area is larger or stroke is relatively coarse processing, it will produce so-called "isolated island", which requires in the path, appropriate to increase the overlap rate.
Woodworking engraving machine engraving software on the "island" of processing there are two main types of processing: Island processing and continuous carving.
The so-called Island processing, is said to the above mentioned some of the processed into the region by the end of the way for processing. The overlap percentage should be defined when the milling is performed ".
Continuous engraving, refers to the above milling plane for the plane as the initial plane, continue to carry out three-dimensional processing. So the actual carving out of the depths of the possible than the design depth to be big, but not more than the height of the blade and the handle. When processing can be appropriate to modify the pick angle distance, pick angle distance, is a three-dimensional processing parameters of the clearance angle. When the larger objects are processed or the rough cutting tools are used, the distance between the pick angles can be increased accordingly. Typically, the proposed use of the default value of 0.1 mm. The distance is too small, may make the number of pick angle too much, the impact of woodworking engraving machine, the effect of the actual processing.